Vapour Phase Soldering Control for PCB Assemblies: 6 Rules Vapour phase soldering heats a board by condensing a hot vapour onto it. The vapour is produced from a fluid with a defined boiling point, and the board can never exceed the temperature of that vapour, which makes the process inherently…

Router Bit Life Management: Edge Quality and Chipout Control Routing separates the parts of a panel with a rotating carbide cutter, and the life of that cutter is the point at which edge quality stops meeting the drawing. Router bit life is not usually ended by a broken tool but…

Flash Plating Control for PCB Copper Surfaces: 5 Rules Flash plating is a short electrolytic plate that puts a thin layer of copper over a surface before the main plating step. It is used to protect a freshly activated surface from oxidation, to establish a continuous conductive path, and to…

Fretting Corrosion in Connectors: Plating Wear and Contact Resistance Fretting corrosion is the damage that occurs when two metal surfaces in contact are rubbed together by a small, repeated motion. In a connector on a printed circuit board the motion is rarely more than a few micrometres and comes from…

Reflow Soak Zone Control in Solder Profiles: 6 Rules The soak zone is the part of a reflow profile between the initial ramp and the ramp to peak, where the board temperature is held roughly level for a period. Its purpose is to let the whole assembly equalise in temperature…

PCB Desmear Traceability: What Buyers and Engineers Should Check Buyers and engineers often focus on the finished product and forget the production line behind it. In practice, most field failures can be traced back to process decisions made during assembly. Understanding PCB desmear traceability gives you a practical advantage when…

PCB Desmear Environment: A Practical Manufacturing Guide Modern electronics depend on boards that are assembled correctly the first time. Every product – a phone, a charger, a medical instrument or an industrial controller – relies on thousands of solder joints that must conduct current for years. This article explains PCB…

Saponifier: Design Rules and Process Limits A saponifier is an alkaline additive that converts flux residue into a water-soluble soap, so that an aqueous cleaner can remove chemistry that plain water would only wet. It is used where a no-clean or rosin-based residue has to be removed but the flux…

PCB Desmear Timing: Design and Assembly Considerations Buyers and engineers often focus on the finished product and forget the production line behind it. In practice, most field failures can be traced back to process decisions made during assembly. Understanding PCB desmear timing gives you a practical advantage when you choose…

Tray Feeder Setup: Pick Position, Vision and Odd Form Parts A tray feeder presents components that cannot travel in tape, so the placement machine can pick them at a defined position. It is the standard way to feed odd form parts, connectors, modules and large parts that would not survive…